C8.3 Industrial Troubleshooting Symptoms Charts Section TS - Troubleshooting Symptoms Page TS-13 Coolant Temperature Above Normal - Gradual Overheat Cause Correction STEP 1 Charge air cooler fins, radiator fins, or air conditioner condenser fins are damaged or Inspect the charge air cooler, air conditioner condenser, and radiator fins. Clean, if necessary. Refer to the OEM service manual. ............. obstructed with debris OK Go To Next Step Open the cold weather radiator cover or the winterfront. Maintain a minimum of 784 cm 2 [122 in 2 ] or approximately 28 x 28 cm [11 x 11 in] of opening at all times. Refer to Procedure 101-004 (Cold Weather Starting) in Section 1.
STEP 2 Cold weather radiator cover or winterfront is closed ............. OK Go To Next Step Inspect the engine and cooling system for external coolant leaks. Repair if necessary. Add coolant. Refer to Procedure 008-066 (Coolant Level) in Section 3. STEP 3 Coolant level is below specification ............. OK Go To Next Step STEP 4 Fan shroud is damaged or missing or the air recirculation baffles are damaged or missing ............. Inspect the shroud and the recirculation baffles. Repair, replace, or install, if necessary. Refer to the OEM service manual. OK Go To Next Step STEP 5 Lubricating oil is contaminated with coolant or fuel .............
Contact a Cummins Authorized Repair Facility. OK Go To Next Step STEP 6 Cooling system hose is collapsed, restricted, or ............. Inspect the hoses. Refer to Procedure 008-086 (Cooling System Hoses) in Section 4. leaking OK Go To Next Step Verify the concentration of antifreeze in the coolant. Add antifreeze or water to correct the concentration. Refer to Procedure 008-046 (Supplemental Coolant Additive (SCA and Antifreeze Concentration)) in Section 6. STEP 7 Coolant mixture of antifreeze and water is not ............. correct OK Go To Next Step STEP 8 Lubricating oil level is above or below specification ............. Check the oil level. Add or drain oil, if necessary.
Refer to Procedure 007-043 (Lubricating Oil Level) in Section 3. OK Go To Next Step