Cummins — 4021330

Troubleshooting Symptoms Charts C8.3 Industrial Page TS-30 Section TS - Troubleshooting Symptoms Engine Runs Rough at Idle Cause Correction Allow the engine to warm to operating temperature. If the engine will not reach operating temperature, refer to the Coolant Temperature Below Normal symptom tree. STEP 1 Engine is cold ............. OK Go To Next Step STEP 2 Idle speed is set too low for accessories ............. Check and adjust the low-idle screw. Refer to the OEM service manual. OK Go To Next Step STEP 3 Fuel pump overflow valve is malfunctioning ............. Check the overflow valve. Replace if necessary. Refer to the OEM service manual.

OK Go To Next Step STEP 4 Fuel transfer pump malfunctioning ............. Inspect the fuel transfer pump. Replace if necessary. Refer to The OEM service manual. OK Go To Next Step Check for air in the fuel system. Tighten or replace the fuel connections, fuel lines, fuel tank standpipe and fuel filters as necessary. Vent air from the system. Refer to Procedure 006-003 (Air in Fuel) in Section A. STEP 5 Air in the fuel system ............. OK Go To Next Step STEP 6 Fuel supply line or passage restriction between the ............. Check the fuel supply line or passage for sharp bends or restriction.

Procedure 006-024 (Fuel Supply Lines) in Section A fuel pump and the injectors OK Go To Next Step STEP 7 Engine mounts are worn, damaged, or not correct ............. Check the engine mounts. Refer to the OEM service manual. OK Go To Next Step STEP 8 Fuel grade is not correct for the application or the ............. Operate the engine from a tank of high-quality fuel. Refer to Procedure 018-002 (Fuel Recommendations and Specifications) in Section V. fuel quality is poor OK Go To Next Step STEP 9 Contact a Cummins® Authorized Repair Facility