C8.3 Industrial Troubleshooting Symptoms Charts Section TS - Troubleshooting Symptoms Page TS-55 Lubricating Oil Contaminated Cause Correction STEP 1 Lubricating oil sludge is excessive ............. Change the oil and filters. Refer to the Lubricating Oil Sludge in the Crankcase Excessive symptom tree. OK Go To Next Step STEP 2 Lubricating oil is contaminated with coolant or fuel ............. Change the oil and filters. Refer to Procedures 007-002 (Lubricating Oil and Filters) in Section 5 and 018-003 (Lubricating Recommendations and Specifications) in Section V. OK Go To Next Step Check the fuel lift pump for correct operation. Check the pump output pressure.
Replace the fuel lift pump if necessary. Refer to the OEM service manual. STEP 3 Fuel lift pump is malfunctioning ............. OK Go To Next Step Check the bulk oil supply. Drain the oil and replace with noncontaminated oil. Replace the oil filter(s). Refer to Procedure 007-002 (Lubricating Oil and Filters) in Section 5. STEP 4 Bulk oil supply is contaminated ............. OK Go To Next Step STEP 5 Contact a Cummins® Authorized Repair Facility