Cummins — 4021330

Lubricating Oil Recommendations and Specifications C8.3 Industrial Page V-10 Section V - Maintenance Specifications Lubricating Oil Recommendations and Specifications New Engine Break-in Oils A sulfated ash limit of 1.85 percent has been placed on all engine lubricating oils recommended for use in Cummins engines. Higher ash oils can cause valve and/or piston damage and lead to excessive oil consumption. CAUTION CAUTION The use of a synthetic-based oil does not justify extended oil change intervals. Extended oil change intervals can decrease engine life due to factors such as corrosion, deposits, and wear.

Special break-in engine lubricating oils are not recommended for new or rebuilt Cummins engines. Use the same type of oil during the break-in as used in normal operation. Additional information regarding lubricating oil availability throughout the world is available in the Lubricating Oils Data Book for Heavy-Duty Automotive and Industrial Engines. It can be ordered from:

Engine Manufacturers Association (EMA), Two North LaSalle Street, Chicago, IL 60602; (www.engine-manufacturers.org) Precautions and Instructions for Proper Kit Use If an engine is operated in ambient temperatures consistently below -23°C [-9°F], and there are no provisions to keep the engine warm when it is not in operation, use a synthetic CE/SF or higher API classification engine oil with adequate low-temperature properties such as 5W-20 or 5W-30. The oil supplier is responsible for meeting the performance service specification represented with its product. General Information Midrange engines with 1999 U.S.A.

certification will have 500-hour maximum oil drain intervals using CES20071 (CH-4) or better lubricating oil. Non-U.S.A. certified engines will have 500-hour oil drain intervals using CES20071 (CH-4) or better lubricating oil. The use of quality engine lubricating oils, combined with appropriate oil drain and filter change intervals, are critical factors in maintaining engine performance and durability.

Cummins recommends the use of a high-quality SAE 15W-40 multiviscosity heavy-duty engine oil, such as Cummins Premium Blue®, that meets the requirements of Cummins Engineering Specification CES20071 or CES20076, or the American Petroleum Institute (API) performance classification CG-4 or CH-4. NOTE: In areas where CG-4 or CH-4 lubricating oils are not available, CES20075 can be used but the lubricating oil change interval must be reduced to 12,070 km [7500 mi], or 250 hours. A sulfated ash limit of 1.0 mass percent is suggested for optimum valve and piston deposit and oil consumption control. The sulfated ash must not exceed 1.85 mass percent.

For further details and discussion of engine lubricating oils for Cummins engines, refer to Cummins Engine Oil Recommendations, Bulletin Number 3810340, or a Cummins Authorized Repair Facility. The use of low-viscosity oils, such as 10W or 10W-30, can be used to aid in starting the engine and in providing sufficient oil flow at ambient temperatures below -5°C [23°F]. However, continuous use of low-viscosity oils can decrease engine life due to wear. Refer to the accompanying chart.