C8.3 Industrial Coolant Recommendations and Specifications Section V - Maintenance Specifications Page V-15 DCA4 Maintenance Guide Notes: A Consult the vehicle equipment manufacturer's maintenance information for the total cooling system capacity. B After draining and replacing the coolant, install the initial per-charge coolant filter to provide the recommended level of DCA4 concentration. C Change the coolant filter at regular intervals to protect the cooling system. D Check the coolant additive concentration regularly. Check the cooling system using Fleetguard® DCA4 only with DCA4 coolant test kit, Part No.CC-2626.
Cooling System Sealing Additives Do not use sealing additives in the cooling system. The use of sealing additives will Build up in coolant low-flow areas Clog coolant filters Plug radiator and oil cooler Possibly damage water pump seal. Cooling System Soluble Oils Do not use soluble oils in the cooling system. The use of soluble oils will Allow cylinder liner pitting Corrode brass and copper Damage heat transfer surfaces Damage seals and hoses. WF-2071 3315116 4 WF-2072 3318201 6 WF-2073 3315115 8 WF-2074 3316053 12 WF-2077 None 0 *If DCA 60L is used, do not use a coolant filter that contains coolant additives.
The combination of liquid and filter coolant additives will result in overconcentration. Maintenance Intervals Total Cooling System Capacity Initial Charge (B) 10,000 km [6000 mi], 250 Hours, or 3 Months 30 to 57 liters [8 to 15 gal] WF-2074 WF-2070