C8.3 Industrial CMD Commercial Application Marine Propulsion(B/C/N14) Section W - Warranty Page W-11 CMD Commercial Application Marine Propulsion(B/C/N14) Coverage Engines Included in this Coverage Marine Propulsion 4B 6B 6C N14 Products Warranted This Warranty applies to new Cummins Engines sold by Cummins MerCruiser Diesel, herein after “CMD”, that are used in Marine propulsion applications anywhere in the world where CMD approved service is available*, and delivered to the first user on or after April 29, 2002. The 'Product' consists of a new Cummins Engine, as well as accessories which are approved and supplied by CMD and which are either installed by CMD or a CMD authorized distributor.
These Products have the following designation: MARINE PROPULSION - Intermittent Rating This power rating is intended for intermittent use in variable load applications where full power is limited to two hours out of every eight hours of operation. Also, reduced power operations must be at or below 200 RPM or the maximum rated RPM. This rating is an ISO3046 Fuel Stop Power Rating and is for applications that operate less than 1,500 hours per year. MARINE PROPULSION - Medium Continuous Rating This power rating is intended for continuous use in variable load applications where full power is limited to six hours out of every twelve hours of operation.
Also, reduced power operations must be at or below 200 RPM of the maximum rated RPM. This rating is an ISO3046 Fuel Stop Power Rating and is for applications that operate less than 3,000 hours per year. MARINE PROPULSION - Heavy Duty Rating This power rating is intended for continuous use in variable load applications where full power is limited to eight hours out of every ten hours of operation. Also, reduced power must be at least 200 RPM below the maximum rated RPM. This rating is an ISO3046 Fuel Stop Power Rating and is for applications that operate less than 5,000 hours per year.
MARINE PROPULSION - Continuous Rating This power rating is intended for continuous use in applications requiring uninterrupted service at full power. This rating is an ISO3046 Standard Power Rating. Base Engine Warranty This Warranty covers any failures of the Product, under normal use and service, which result from a defect in CMD material or factory workmanship (Warrantable Failure). Coverage begins with the sale of the Engine by CMD and continues for the duration stated in the following table.
The duration commences on either the date of delivery of the Product to the first user, or the date the unit is first leased, rented or loaned, or when the Product has been operated for 50 hours, whichever occurs first. Extended Major Components Warranty The Extended Major Components Warranty applies to Engines other than B and C Series. It covers Warrantable Failures of the Engine cylinder block, camshaft, crankshaft and connecting rods (Covered Parts). Bushing and bearing failures are not covered.
This Coverage begins with the expiration of the Base Engine Warranty and ends after three years or 10,800 hours of operation, whichever occurs first, from the date of delivery to the first user, or the date the unit is first leased, rented or loaned, or when the Product has been operated for 50 hours, whichever occurs first. Consumer Products The Warranty on Consumer Products in the United States is a limited Warranty. CMD IS NOT RESPONSIBLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. Any implied Warranties applicable to Consumer Products terminate concurrently with the expiration of the express Warranties applicable to the Product.
In the United States, some states do not allow the exclusion of incidental or consequential damages, or limitations on how long an implied Warranty lasts, so the limitations or exclusions herein may not apply to you. Duration Whichever Occurs First Rating Years Hours Intermittent 1 1,500 Medium Continuous 1 3,000 Heavy Duty 1 5,000 Continuous 1 Unlimited