Air Intake Piping C8.3 Industrial Page 3-8 Section 3 - Maintenance Procedures at Daily Interval Assemble Marine Applications Install the sea water strainer. Inspect o-ring seal for tears or damage. Replace if necessary. Be sure o-ring is seated properly. Install and tighten the wing nut(s). Open the sea water inlet valves. Air Intake Piping Maintenance Check Inspect the intake piping daily for wear points and damage to piping, loose clamps, and punctures that can damage the engine. Replace damaged pipes and tighten loose clamps, as necessary, to prevent the air system from leaking. Torque Value: 8 N•m [ 71 in-lb ] Check for corrosion under the clamps and hoses of the intake system piping.
Corrosion can allow corrosive products and dirt to enter the intake system. Disassemble and clean, as required.