C8.3 Industrial Drive Belts Section 3 - Maintenance Procedures at Daily Interval Page 3-9 Air Tanks and Reservoirs Drain If automatic purging or spitter valves are used, confirm the valves are operating correctly. If a manual drain valve is used on the wet tank, open the draincock on the wet tank to drain any moisture accumulated in the air system. If oil is present, the air compressor system must be checked. Contact your Cummins Authorized Repair Location. Marine Gear Maintenance Check Marine Applications Check the marine gear oil level daily. Refer to the OEM's recommendations for the gear oil requirements. NOTE:
Different models of marine gears will have the marine gear oil dipstick and fill cap in different locations. The location shown is typical. Drive Belts Maintenance Check Poly-Vee Belt CAUTION Make sure that the engine is switched off and any starting mechanisms are isolated before any inspections are made. Daily belt inspections can be carried out through an appropriate aperture. Do not remove any guards. Inspect the belts daily. Check the belt for intersecting cracks. Traverse (across the belt width) cracks are acceptable. Longitudinal (direction of belt length) cracks that intersect with transverse cracks are not acceptable.
Replace the belt if it is frayed or has pieces of material missing. Refer to Section A for belt adjustment and replacement procedures. Belt damage can be caused by: Incorrect tension Incorrect size or length Pulley misalignment Incorrect installation Severe operating environment Oil or grease on the side of belts.