Cummins — 4021330

C8.3 Industrial Zinc Anode Section 4 - Maintenance Procedures at 75 Hours, or 3 Months Page 4-1 Maintenance Procedures - Overview General Information All maintenance checks and inspections listed in previous maintenance intervals must also be performed at this time, in addition to those listed under this maintenance interval. Zinc Anode Remove Shut off the sea water inlet valve on the vessel hull. CAUTION In some cases, it will be necessary to hold the welded fitting on the heat exchanger with an additional wrench to prevent damage to the heat exchanger. Remove the zinc plug(s). NOTE: The illustration shown is generic. For engine- specific locations, see to Section E.

Inspect for Reuse Measure the length of the zinc plug(s) removed from the heat exchanger. Replace any zinc plug if it is 50 percent or more eroded. NOTE: The frequency of change depends on the chemical reaction of the sea water circulated through the heat exchanger.