Cummins — 4021330

Batteries C8.3 Industrial Page 4-4 Section 4 - Maintenance Procedures at 75 Hours, or 3 Months Industrial Gas Mechanical Indicator A mechanical restriction indicator is available to indicate excessive air restriction through a dry-type air cleaner. This instrument is mounted in the air cleaner outlet. The red flag (1) in the window gradually rises as the cartridge loads with dirt. When air restriction is indicated the air filter must be replaced. After changing or replacing the cartridge, reset the indicator by pushing the reset button (2) Batteries Inspect Use an inductive charging and cranking system analyzer to load-test the state of charge of maintenance-free batteries.

If the state of charge is low, use a battery charger to charge the battery. Refer to the manufacturer's instructions. Replace the battery if it will not charge to the manufacturer's specifications or the battery will not maintain a charge. If conventional batteries are used, remove the cell caps or covers and check the electrolyte (water and sulfuric acid solution) level. WARNING Batteries can emit explosive gas. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the battery (-) negative cable first and attach the battery negative cable last. NOTE:

Maintenance-free batteries are sealed and do not require the addition of water. Fill each battery cell with water. Refer to the manufacturer's specifications. Refer to the accompanying table to determine the battery state of charge based on the specific-gravity readings. Battery State of Charge Specific Gravity @ 27°C [80°F] 100% 1.260 to 1.280 75% 1.230 to 1.250 50% 1.200 to 1.220 25% 1.170 to 1.190 Discharged 1.110 to 1.130