Cummins — 4021330

C8.3 Industrial Component Connector and Pin Inspection Section 4 - Maintenance Procedures at 75 Hours, or 3 Months Page 4-7 Bent or Expanded Pins Inspect the male terminals of the connector. If any of the terminals are bent, so that they will not easily mate with the other side of the connector, or if the male terminals are expanded, that is, bulged out or squashed so as to make them too large to mate with the other side of the connector, then the pin must be replaced. Refer to the repair section for the specific connector in question. Corroded Pins Inspect both the male and female terminals for corrosion, which can cause a poor electrical connection within the connector.

If any corrosion is evident on the pins, then the corroded pins must be replaced. Refer to the repair section for the specific connector in question. Pushed Back Pins Inspect both the male and female terminals for pins that can not be making contact because they are pushed back in the connector. To repair, push the pin into the connector body from the back of the connector. Make sure the terminal locks into place. If the terminal will not lock into place, then replace it. Refer to the repair section for the specific connector in question.