C8.3 Industrial Fuel Filter (Spin-On Type) Section 5 - Maintenance Procedures at 250 Hours or 3 Months Page 5-1 Maintenance Procedures - Overview General Information All maintenance checks and inspections listed in previous maintenance intervals must also be performed at this time, in addition to those listed under this maintenance interval. Fuel Filter (Spin-On Type) Clean Clean the area around the fuel filter head. Remove 75- to 80-mm and 90- to 95-mm Wrenches Remove the fuel filter. Clean the gasket surface of the fuel filter head. Install Replace the o-ring. Fill the new fuel filter(s) with clean fuel, and lubricate the o-ring seal with clean lubricating engine oil.