Fuel Filter (Spin-On Type) C8.3 Industrial Page 5-2 Section 5 - Maintenance Procedures at 250 Hours or 3 Months To reduce the possibility of fuel leaks, make sure the fuel filter is installed tightly but not too tightly. Mechanical overtightening will damage the fuel filter. CAUTION Install the fuel filter as specified by the filter manufacturer. Prime Controlled venting is provided at the injection pump through the fuel drain manifold. Small amounts of air introduced by changing the fuel filters or fuel injection pump supply line will be vented automatically if the fuel filter is changed in accordance with the instructions. Manual bleeding is required if:
The fuel filter is not filled prior to installation Fuel injection pump is replaced High-pressure fuel line connections are loosened or fuel lines replaced Initial engine start up or start up after an extended period of no engine operation occurs Vehicle fuel tank has been run until empty. Open the bleed screw. Operate the plunger on the fuel transfer pump until the fuel flowing from the fitting is free of air. Tighten the bleed screw. Torque Value: 9 N•m [ 80 in-lb ]