Lubricating Oil and Filters C8.3 Industrial Page 5-4 Section 5 - Maintenance Procedures at 250 Hours or 3 Months NOTE: If the engine is in service, under no circumstances can the lubricating oil drain interval extend beyond the intervals given in the charts. Change the lubricating oil and filters to remove the contaminants suspended in the lubricating oil. NOTE: Drain the lubricating oil only when it is hot and the contaminants are in suspension. WARNING To reduce the possibility of personal injury, avoid direct contact of hot oil with your skin. Use a container that can hold at least 25 liters [26 qt] of lubricating oil. Operate the engine until the water temperature reaches 60°C [140°F].
Shut off the engine . Remove the lubricating oil drain plug. NOTE: Some applications such as marine, industrial, or generator drives have limited accessibility to oil drains. Alternate methods are available for removing oil such as pump out systems. Check with local dealer or distributor for information. Remove Clean the area around the lubricating oil filter head. Remove the filter. Clean the gasket surface of the filter head. The o-ring can stick on the filter head. Make sure it is removed. Install Fill the filters with clean lubricating oil before installation. NOTE: The LF3000 lubricating oil filter has two gaskets. Lubricate both gaskets.
Apply a light film of oil to the gasket sealing surface before installing the filters.