SERIES 50 OPERATOR'S GUIDE 3. Dispose of used oil and filters in an environmentally responsible manner, according to federal (EPA) and/or state recommendations. PERSONAL INJURY Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm. 4. Clean the filter gasket-contact surface of the adaptor head with a clean, lint-free cloth. 5. Fill the new filters with clean lubricating oil and lightly coat the filter gaskets with the same oil. Always start and operate an engine in a well ventilated area. 6. Start the new filters on the adaptor head and tighten by hand until the gaskets touch the mounting adaptor head.
Tighten filters an additional two-thirds turn by hand, or as indicated on the filter. If operating an engine in an enclosed area, vent the exhaust to the outside. Do not modify or tamper with the exhaust system or emission control system. NOTICE: 8. Start and run the engine for a short period and check for leaks. After any leaks have been corrected, stop the engine long enough for oil from various parts of the engine to drain back to the crankcase (approximately 20 minutes). Add oil as required to bring the level to the “Full” mark on the dipstick. Do not overtighten filters. Overtightening may crack or distort the filter adaptor. 7.
Add oil as required to bring the level to the “Full” mark on the dipstick. All information subject to change without notice. (Rev. 01/04) 87 DDC-SVC-MAN-0058 Copyright © 2004 DETROIT DIESEL CORPORATION