HOW-TO SECTION Oil analysis may be used to determine whether this interval should be shortened, but it should not be used to lengthen the interval. system. Filter part numbers are listed in the Specifications section of this guide. The use of fuels with sulfur content above 0.05 mass percent will require a shortening of drain intervals and/or the use of a higher TBN oil. See the information listed in Table 20. For detailed information refer to publication Engine Requirements – Lubricating Oil, Fuel and Filters (7SE270), available from authorized Detroit Diesel distributors. Replace Spin-On Type Oil Filter Replace spin-on type filters as follows: 1.
Place a suitable container under the engine oil pan, remove drain plug and drain the lubricating oil. Replace the drain plug and tighten securely. 2. Remove spin-on filters using tool J 29917, or equivalent, and a 1/2-inch drive socket wrench and extension. Disposing of Waste Oil Dispose of used lubricating oil and filters in an environmentally responsible manner, according to federal (EPA) and/or state recommendations. The disposal of waste oil may be best addressed by the engine oil supplier, who may accept responsibility for proper disposal of this material as part of the business of providing lubricant.
How to Replace the Lube Oil Filters Filters are an integral part of the lubricating oil system. Proper filter selection and maintenance are important to satisfactory engine performance and service life. Filters should be used to maintain a clean system, not to clean up a contaminated Figure 23 Spin-On Oil Filters 86 All information subject to change without notice. (Rev. 01/04) DDC-SVC-MAN-0058 Copyright © 2004 DETROIT DIESEL CORPORATION