HOW-TO SECTION Replace Spin-On Type Primary or Secondary Fuel Filter Elements 5. If not previously filled, fill new replacement filters with clean diesel fuel and coat the gaskets lightly with the fuel oil. Replace spin-on fuel filter elements as follows: 6. Thread the new filters onto the adaptor inserts until the gaskets make full contact with the adaptor head and no side movement is evident. Tighten filters an additional one-half turn by hand, or as indicated on the filter. 1. Shut down the engine and allow it to cool. 2. With the engine at ambient temperature and cool to the touch, place a suitable container under the filter. 3.
A fuel shutoff valve may be installed on the discharge side of the secondary fuel filter. If installed, turn the handle on the shutoff valve to the closed position (perpendicular to the valve). NOTICE: To improve engine starting, have replacement filters filled with fuel and ready to install immediately after used filters are removed. This will prevent possible siphoning and fuel system aeration. 4. Using a suitable band type filter wrench, remove the primary and secondary fuel filters. See Figure 24. Dispose of the filters in an environmentally responsible manner, according to federal (EPA) and/or state recommendations.
Figure 24 Typical Spin-On Type Fuel Filter 90 All information subject to change without notice. (Rev. 01/04) DDC-SVC-MAN-0058 Copyright © 2004 DETROIT DIESEL CORPORATION