MAN — MAN Series 50 Operator's Guide

SERIES 50 OPERATOR'S GUIDE NOTICE: equivalent. Authorized Detroit Diesel distributors are properly equipped to perform this service. Do not overtighten the filter. Overtightening may crack or distort the adaptors. NOTICE: 7. Turn the handle on the shutoff valve to the Open position (in line with the valve). Under no circumstances should the starting motor and fuel pump be used to prime the fuel filters. Prolonged used of the starting motor and fuel pump to prime the fuel system can result in damage to the starter, fuel pump and injectors and cause erratic running of the engine due to the amount of air in the fuel lines and filters.

PERSONAL INJURY Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm. Replace Fuel/Water Separator Element Always start and operate an engine in a well ventilated area. If an optional primary filter/water separator is installed, replace the element as follows: If operating an engine in an enclosed area, vent the exhaust to the outside. 1. Shut down the engine and allow it to cool. Do not modify or tamper with the exhaust system or emission control system. 2. With the engine at ambient temperature and cool to the touch, place a suitable container under the filter. 3.

A fuel shutoff valve may be installed on the discharge side of the fuel/water separator. If installed, turn the shutoff valve handle to the closed position (perpendicular to the valve). 8. Start the engine and check for leaks. Shut down the engine. Correct any leaks with the engine off. If the engine fails to start after filter replacement, the fuel system will require priming with tool J 5956, or 4. Drain off some fuel by opening the drain All information subject to change without notice. (Rev. 01/04) 91 DDC-SVC-MAN-0058 Copyright © 2004 DETROIT DIESEL CORPORATION