MAN — MAN Series 50 Operator's Guide

HOW-TO SECTION Definitions Do not allow the fuel level in the see-thru cover to fall below the top of the collar, since this may lead to interruption of the fuel flow and engine stalling. NOTICE: This section covers selection of the required coolant for Series 50 engines. To help ensure complete understanding of the information, the definitions of the following terms are provided: 2. Start the engine and allow the lubrication system to reach its normal operating pressure, then increase engine speed to high idle for 2 to 3 minutes. After the air is purged and with the engine still running, loosen the vent cap on the filter cover. the fuel level in the cover will start falling.

When the fuel level falls to the top of the collar on the Fuel Pro cover, tighten the vent cap quickly by hand . Antifreeze Ethylene glycol or propylene glycol containing a corrosion inhibitor package and which meets an appropriate heavy-duty specification (i.e., TMC RP-329 for ethylene glycol or TMC RP-330 for propylene glycol). Coolant The fluid mixture circulating in the engine cooling system, typically a mixture of 50% water and 50% antifreeze. NOTE: If the engine fails to start after replacement of fuel filters, the fuel system will require priming with tool J 5956, or equivalent. Authorized Detroit Diesel distributors are properly equipped to perform this service.

Drop-Out Precipitated sludge or deposit formation on cooling system components. Fully Formulated Antifreeze Contains all the necessary inhibitors to protect a diesel engine, and does not, therefore, require a pre-charge of SCA before its first use. How to Select Coolant The section coves selection of the required coolant for Series 50 engines. Initial–Fill Coolant The coolant that is used in a new or rebuilt engine, or any time the cooling system is emptied and then refilled with coolant. 96 All information subject to change without notice. (Rev. 01/04) DDC-SVC-MAN-0058 Copyright © 2004 DETROIT DIESEL CORPORATION