MAN — MAN Series 50 Operator's Guide

OPERATING INSTRUCTIONS FOR A FIRST TIME START If the engine is equipped with a fuel/water separator, drain off any water that has accumulated. Water in fuel can seriously affect engine performance and may cause engine damage. Detroit Diesel recommends installation of a fuel/water separator wherever water contamination is a concern. Check drive belts to make sure they are in good condition (not cracked, torn, worn or glazed) and are properly adjusted. If lead-acid or low-maintenance batteries are used, make sure battery electrolyte level is normal. Check the turbocharger for signs of oil or exhaust leaks. Leaks should be corrected before starting the engine.

Other Checks Check engine mounting bolts for tightness. Bolts should be retightened, if necessary. Make sure the transmission is filled to the proper level with the fluid recommended by the gear manufacturer. Do not overfill. Make sure cable connections to the storage batteries are clean and tight. Check the hydrometer “eye” of maintenance-free batteries for charge. See Figure 5. Starting the Engine Before starting the engine the first time, refer to the System Checks section and perform the operations listed. NOTICE: The turbocharger may be seriously damaged if the engine is cranked with the air shutdown in the closed position.

If the engine has an emergency manual or automatic shutdown system, make sure the control is set in the open position before starting. Figure 5 Maintenance-Free Battery The engine may require the use of a cold weather starting aid if the ambient temperature is below 40° F (4° C). 18 All information subject to change without notice. (Rev. 01/04) DDC-SVC-MAN-0058 Copyright © 2004 DETROIT DIESEL CORPORATION