SERIES 50 OPERATOR'S GUIDE OK, both lights will go out in approximately five seconds. FLAMES, EXPLOSION AND TOXICITY Start the engine after the lights go out. If starting a vehicle, start the engine with foot off the foot pedal. To avoid injury from flames, explosion, and toxicants when using ether, the following precautions must be taken: NOTICE: If the operating lights stay on, consult with DDC Technical Service. Operating the engine under these circumstances may result in engine damage. Do not smoke when servicing ether system. Work in well ventilated area. Do not work near open flames, pilot flames (gas or oil heaters), or sparks.
Do not weld or carry an open flame near the ether system if you smell ether or otherwise suspect a leak. Electric Starter Start an engine equipped with an electric starting motor as follows: 1. With foot OFF the foot pedal, press the starter switch firmly. Initial Engine Start NOTICE: To start a Series 50 engine, make sure the transmission is in neutral and turn the ignition key on. To prevent serious starting motor damage, do not press the starter switch again after the engine has started. You will notice that both the yellow Check Engin Light (CEL) and the red Stop Engine Light (SEL) will come on. 2.
If the engine fails to start within 15 seconds, release the starter switch and allow the starter to cool for 15 seconds before trying again. If the engine fails to start after four attempts, an inspection should be made to determine the cause. This is the result of theDetroit Diesel Electronic Control (DDEC®) computer diagnosing the system to ensure everything is functional, including the light bulbs for the warning lights. If everything is All information subject to change without notice. (Rev. 01/04) 19 DDC-SVC-MAN-0058 Copyright © 2004 DETROIT DIESEL CORPORATION