SERIES 50 OPERATOR'S GUIDE Item 10 Air Cleaner Inspect the entire air system for leaks daily. Look especially for torn air inlet piping or boots and loose or damaged clamps. Have worn or damaged parts repaired or replaced, as required. Retighten loose connections. The air cleaner element should be inspected every 15,000 miles (24,000 km) for vehicle engines, 150 hours for non-vehicle engines, or more often if the engine is operated under severe dust conditions. Replace the element, if necessary. Check the gaskets for deterioration and replace, if necessary. If the dry type air cleaner is equipped with an aspirator, check for aspirator damage or clogging.
Clean, repair or replace, as necessary. Item 11 – Lubricating Oil Filters For on-highway vehicle engines, install new spin-on oil filters at a maximum of 15,000 miles (24,000 km). For city transit coach engines, install filters at a maximum of 6,000 miles (9,600 km). Dry type air cleaner elements should be replaced after one year of service or when the maximum allowable air intake restriction has been reached, whichever comes first. Refer to section When to Service the Dry Type Air Cleaner in this guide for additional information. For industrial engines, install filters every 150 hours of operation or each time the engine oil is changed, whichever comes first. NOTICE:
Do not allow the air inlet restriction to exceed 20 inches of water (5.0 kPa) under any engine operating conditions. A clogged air cleaner element will cause excessive intake restriction and a reduced air supply to the engine. This, in turn, can result in increased fuel consumption, inefficient engine operation and reduced engine life. PERSONAL INJURY To avoid injury from slipping and falling, immediately clean up any spilled liquids. All information subject to change without notice. (Rev. 01/04) 75 DDC-SVC-MAN-0058 Copyright © 2004 DETROIT DIESEL CORPORATION