MAINTENANCE Install the new filters, turning them until they contact the gasket fully with no side movement. Turn full-flow filters an additional 2/3 turn by hand , or as indicated on the filter. See Figure 16. fuel pressure at the cylinder head fuel inlet fitting and the inlet restriction at the fuel pump. In a clean system the maximum pump inlet restriction should not exceed 6 inches of mercury (20.3 kPa). In a dirty system it must not exceed 12 inches of mercury (41 kPa). At normal operating speed and with the standard .080 inch restriction fittings, the fuel pressure is 55 – 70 psi (375 – 483 kPa).
Change the fuel filters whenever the inlet restriction at the pump reaches 12 inches of mercury (41 kPa) at normal operating speeds and whenever the fuel pressure at the inlet fitting falls to the minimum fuel pressure of 6 inches of mercury (20.3 kPa). NOTE: Filter change intervals may be shortened to conform with established preventive maintenance schedules, but should never be extended. Figure 16 Lubricating Oil Filters Make a visual check of all lubricating oil lines for wear and/or chafing. If any indication of wear is evident, replace the oil lines and correct the cause.
Fuel Pro® 382 Filters Install new Fuel Pro® 382 primary fuel filter elements when the fuel level in the see-thru cover reaches the top of the element or after one year of service, whichever comes first. Check for oil leaks after starting the engine. Item 12 Fuel Filters One method of determining when filters are plugged to the extent that they need replacing is based on the Spin-On Filters Install new spin-on primary and secondary fuel filter elements on vehicle engines every 15,000 miles (24,000 km) or 76 All information subject to change without notice. (Rev. 01/04) DDC-SVC-MAN-0058 Copyright © 2004 DETROIT DIESEL CORPORATION