MAN — MAN Series 50 Operator's Guide

SERIES 50 OPERATOR'S GUIDE every six months, whichever comes first. See Figure 17. coolant does not leak from the drain hole under normal conditions, do not replace the water pump. Coolant Inhibitor Element If the cooling system is protected by a supplemental coolant additive (SCA) element, the coolant must be tested at required intervals and the element replaced, if required. See Figure 18. Figure 17 Spin-On Fuel Filter Location Install new spin-on filter elements on non-vehicle engines every 150 hours. Replace spin-on filter elements immediately if plugging is indicated, regardless of mileage or hour intervals.

Item 13 Water Pump and Coolant Inhibitor Element Check the water pump and the coolant inhibitor element. Water Pump Drain Hole The water pump drain hole should be inspected every 6 months to make sure it is open. A small chemical build-up or streaking at the drain hole may occur. This is not an indication of a defective water pump or seal. Remove the build-up with a mild detergent cleaner and a brush. If Figure 18 Coolant Inhibitor Element Required test intervals are listed in Table 25. For SCA test procedures refer to How to Select Coolant and then SCA Test Procedures in this guide. Use the coolant filter element required. All information subject to change without notice. (Rev.

01/04) 77 DDC-SVC-MAN-0058 Copyright © 2004 DETROIT DIESEL CORPORATION