Ch 2 page 113 TRANSMISSION Clutch “A“ Disengage and remove both rectangular rings (1). Figure 303 Idler Pull the bearing inner ring off the shaft. (S) Grab sleeve 850317-00081 Figure 304 Remove the snap ring Figure 307. On the 4 assembly openings of the gear press the snap ring with a screwdriver flush into the annular groove of the shaft (see Figure 305) and pull off the gear by means of the 3-armed puller at the same time. Figure 305 Legend: 1 = Idler 2 = Gear 3 = Shaft 4 = Snap ring Figure 306 SHOP MANUAL