TRANSMISSION Ch 2 page 114 Remove the gear (1) and disengage the snap ring (2). Figure 307 Remove the single parts. 1 = Axial bearing cpl. *Axial washers *Axial bearing 2 = Idler 3 = Needle cage 4 = Axial bearing cpl. *Axial washer *Axial bearing *Running disk Figure 308 Gear Pull the bearing inner ring off the shaft. (S) Grab sleeve 850317-00081 Figure 309 Remove the snap ring Figure 312. On the 4 assembly openings of the gear press the snap ring with a screwdriver flush into the annular groove of the shaft (see Figure 310) and pull off the gear by means of the 3-armed puller at the same time. Figure 310 SHOP MANUAL