Ch 2 page 163 TRANSMISSION Heat up the internal teeth of the gear (approx. 120° C). Figure 493 Assemble the gear (1) until the snap ring has engaged into the recess of the gear. NOTE Both ends of the snap ring must be located in one of the four mounting holes (see arrows)! The snap ring must be engaged into both recesses of shaft and gear! Use safety gloves! Figure 494 Heat up the bearing inner ring of the taper roller bearing (approx. 120° C). Figure 495 Assemble the bearing inner ring (1) until contact. WARNING Use safety gloves! Adjust the bearing inner ring after cooling down! Figure 496 SHOP MANUAL WARNING CAUTION