TRANSMISSION Ch 2 page 198 Install two adjusting screws. NOTE Observe installation position stator/oil supply flange! See hole pattern (arrows)! (S) Adjusting screw 120702-00081 Figure 622 Insert the stator (1) into the oil supply flange (2). Figure 623 Install the bolted connection/oil supply flange with torx screws (1 and 2). 1 = M6/10.9x25 2 = M6/10.9x18 Tightening torque MA = 9.5 Nm Figure 624 Insert the axial bearing (1) into the rotor and oil it. Figure 625 SHOP MANUAL