Ch 2 page 199 TRANSMISSION Assemble the axial washer (1), oil it and put on the roto (2). NOTE Observe installation position axial washer (1)! See detail Figure 626 By means of a suitable tool press the sleeve (1) into the sealing disc (2) until contact is obtained. Pay attention to the position of the fixing straps 3x! Figure 627 Check position of the straps (1) on the pressed-in oil supply flange. To lock the sleeve bent three straps outward. Figure 628 Put on the sealing disc (1) and fasten it with torx screws (2). Tightening torque (M8/10.9x60) MA = 23 Nm Insert the rectangular ring (3) and grease it. Figure 629 SHOP MANUAL