TRANSMISSION Ch 2 page 200 Primary pump Insert the inner rotor (1) and the outer rotor (2) into the pump housing (3). NOTE Chamfer on the outer rotor (see arrow) shows downwards! Install cover (4) to the pump housing until contact. Figure 630 Install the bolted connection cover/pump housing (1). Tightening torque MA = 20 ± 2 Nm Figure 631 Installation retarder, primary pump, valve block and shifting block II Snap in the snap ring (1) and mount the flange bush (2) Pay attention to installation position of the flange bush (2). (see Figure 632). Figure 632 Mount O-ring 95x3 (1) onto the input shaft of clutch “V” and grease it. Figure 633 SHOP MANUAL