Ch 2 page 201 TRANSMISSION Assemble cup springs (1) and washer (2) to the input shaft of clutch Pay attention to installation position of cup springs and washer. (see Figure 634) Figure 634 Legend: 1 = Rectangular ring 65x3 2 = Rectangular ring 70x3 3 = Bush 4 = O-ring 95x3 5 = Cup springs (2 pcs.) 6 = Flange bush 7 = Snap ring G = Housing I A = Input shaft clutch “V” AN = Input shaft P = PTO shaft Figure 635 Install the rectangular rings (1 and 2). 1 = 65x3 2 = 70x3 Align and grease the rectangular rings. See Figure 636. Figure 636 Install the adjusting screws and mount the cover plate (1) until contact is obtained.
(S) Adjusting screw 120702-00080 (M10) (S) Adjusting screw 120702-00082 (M8) It is forbidden to reinstall the cover plate after opening of the bolted connection oil supply flange/housing I. In case of repair a new cover plate is generally to be installed! Figure 637 SHOP MANUAL NOTE