Ch 2 page 47 TRANSMISSION 7. Loosen the screw (1) and remove the speed sensor (2). Figure 63 8. Open and separate the lockings of speed sensors (1 and 2) and differential lock solenoid valve (3). 9. Loosen the Torx screws (4) and remove fixing plate (5) with speed sensors. 10. Loosen the cylindrical screws (6) of the fixing bracket. Figure 64 11. Loosen the cylindrical screws (1) and remove the speed sensors (2). Figure 65 Dismantling the valve block 1. Open all lockings and separate them from pressure controllers and solenoid valve. 2. Remove the fixing bracket (1). 3. Press the bayonet locking of wiring harness out of the hole (see arrow). Figure 66 SHOP MANUAL