Table a. MI-04 Diagnostic Fault Codes (Flash Codes) G420E/G424E Tier LP Engine Advanced Diagnostics 49 DFC Probable Fault Action Corrective Action, First Check 23 ThrottleSensorInputHi TPS1 sensor failure or shorted circuit Disable Throttle Check throttle connector and TPS1 sensor wiring for a shorted circuit ETC PIN 6 to SECM PIN 17 (SIGNAL) ETC PIN 2 to SECM PIN 1 (GND) 24 ThrottleSensorRangeLo TPS1 potentiometer malfunction. Improper TPS reading may be due to dirt or oxidation on the sensor traces. Stored Fault Code (MIL Only) Check the throttle connector and pins for corrosion.
Perform Throttle test with the Service Tool several times to clean sensor To check the TPS disconnect the throttle connector and measure the resistance (1.25KΩ +/-30%) from TPS PIN 2 (GND) to PIN 6 (TPS1 SIGNAL) TPS PIN 3 (PWR) to PIN 6 (TPS1 SIGNAL) *See Chapter 6.0 for sensor checks 25 ThrottleSensorRangeHi TPS1 potentiometer malfunction. Improper TPS reading may be due to dirt or oxidation on the sensor traces. Stored Fault Code (MIL Only) Check the throttle connector and pins for corrosion.
z Perform Throttle test with the Service Tool several times to clean sensor To check the TPS disconnect the throttle connector and measure the resistance (1.25KΩ +/-30%) from TPS PIN 2 (GND) to PIN 6 (TPS1 SIGNAL) TPS PIN 3 (PWR) to PIN 6 (TPS1 SIGNAL) *See Chapter 6.0 for sensor checks