Table a.
MI-04 Diagnostic Fault Codes (Flash Codes) G420E/G424E Tier LP Engine Advanced Diagnostics 50 DFC Probable Fault Action Corrective Action, First Check 26 ETCSticking Throttle plate sticking inside the throttle body or the ETC driver signal is open Engine Shutdown Check for debris or obstructions inside the throttle body Perform the Throttle test using the Service Tool and re-check for fault Check throttle-plate shaft for bearing wear Check the ETC driver wiring for an open circuit ETC+ PIN 1 to SECM PIN 22 ETC-PIN 4 to SECM PIN 24 Check the ETC internal motor drive by disconnecting the throttle connector and measuring the motor drive resistance at the throttle TPS PIN 1 (+DRIVER) to PIN 4 (- DRIVER) ~3.0Ω +/-30% 27 PredictedTPSDifference Measured TPS1 is different than SECM Calculated throttle position Engine Shutdown Check for manifold leaks between the throttle and the engine Note:
Fault Code 27 is predicted TPS. This fault means that the throttle and our calculated prediction for throttle do not agree. This code often comes up as suspected during transient manuevers. It is not system trouble. If the fault really sets, then the engine will shut down. 28 ETCSpringTestFailed Upon initial key-up the internal throttle return spring has become weak Power Limit Perform throttle spring test by cycling the ignition key and re-check for fault