daewoo — Daewoo SB4136E00 Service Manual for G420E/G424E Tier LP Engine Lift Trucks

Table a.

MI-04 Diagnostic Fault Codes (Flash Codes) G420E/G424E Tier LP Engine Advanced Diagnostics 51 DFC Probable Fault Action Corrective Action, First Check 29 ETCDriverFault Throttle driver over-current or driver signals shorted Disable Throttle Check ETC driver wiring for a shorted circuit ETC+ PIN1 to SECM PIN 22 ETC- PIN 4 to SECM PIN 24 z Perform Throttle test and with the Service Tool and re-check for fault Check the ETC internal motor drive by disconnecting the throttle connector and measuring the motor drive resistance at the throttle TPS PIN 1 (+DRIVER) to PIN 4 (- DRIVER) ~3.0Ω +/-30% 33 MapSensorInputLow MAP signal disconnected, open circuit or sensor malfunction (Expected faults when TMAP connector is unplugged CODES:

33 & 38) Disable Throttle Check TMAP connector and MAP signal wiring for an open circuit TMAP PIN 4 to SECM PIN 5 (SIGNAL) TMAP PIN 1 to SECM PIN 1 (GND) TMAP PIN 3 to SECM PIN 18 (XDCR +5VDC) Check the MAP sensor by disconnecting the TMAP connector and measuring at the sensor TMAP PIN 1(GND) to PIN 4 (PRESSURE SIGNAL KPA) (2.4kΩ - 8.2kΩ) TMAP PIN 3(PWR) to PIN 4 (PRESSURE SIGNAL KPA) (3.4kΩ - 8.2kΩ)