Table a.
MI-04 Diagnostic Fault Codes (Flash Codes) G420E/G424E Tier LP Engine Advanced Diagnostics 54 DFC Probable Fault Action Corrective Action, First Check 43 EST1High Coil driver signal high or over-current Stored Fault Code (MIL Only) Check coil driver wiring for an open circuit or disconnected connector SECM PIN 7(EST1) to COIL PIN A Verify GND on COIL PIN B Verify GND on COIL PIN C Verify GND on COIL PIN D Verify +12vdc on COIL PIN E To check the Smart Coil internal circuit disconnect the coil connector and measure the resistance from pin to pin *See Smart Coil resistance check in Chapter 6.0 53 BatterySensorInputLow Battery voltage measured below +8.0 VDC Stored Fault Code (MIL Only) Check battery voltage z Perform maintenance check on electrical connections to the battery and chassis ground z Check battery voltage during starting and with the engine running to verify charging system and alternator function Measure battery power at the SECM with a multimeter SECM PIN 13 (BATT +) to SECM PIN 14 (BATT -)