4. Loosen the distributor hold down nut and rotate the distributor so that the signal rotor gear tooth of the #1 cylinder (tooth opposite the flat side of the distributor shaft) lines up with the sensor pickup. (Figure G4). 5. To correctly set the distributor, align the center of the #1 cylinder tooth with the leading edge of the VR sensor pickup (Figure G5). Keep in mind that the distributor rotates in a clockwise direction. 6. Once the proper alignment is obtained, lock the distributor in place by tightening the hold down nut to the specified torque value and re-install the rotor, dust cover and rotor cap.
WARNING Improper alignment of the distributor may cause system ignition problems resulting in ignition misfires or backfires. Incorrect Alignments #1 Tooth Flat Side of Shaft Figure G4 G420E/G424E Tier LP Engine Test And Adjustments 83 1 Figure G5 Correct Alignment