daewoo — Daewoo SB4136E00 Service Manual for G420E/G424E Tier LP Engine Lift Trucks

Ignition Timing Adjustment With the MI-04 system both mechanical and vacuum advance are no longer inside the distributor. All ignition timing advance is controlled by the SECM. The only timing adjustment that can be made by a technician is the mechanical alignment of the distributor. The SECM uses a 40-degree timing window from –5 degrees BTDC to 35 degrees BTDC. Because of this an accurate adjustment cannot be made with a standard timing light since the SECM will maintain the correct timing even if the distributor is moved (as long as the distributor setting remains within the 40-degree window).

Therefore the ignition timing setting of the distributor becomes very important and is described in the following steps. 1. Using the timing indicator on the crankshaft pulley, set the engine on 0 degrees Top Dead Center (TDC) of number 1 cylinder (Figure G1). 2. Remove the distributor rotor cap and verify that the distributor rotor is lined up with number 1 cylinder on the distributor cap (Figure G2). 3. Remove the distributor rotor and dust cover so that the internal VR sensor and signal rotor gear are visible (Figure G3).

The internal VR sensor inside the distributor is not used by the SECM for a speed reference with the G420E/G424E engine and it’s wiring harness does not connect to the system. The distributors internal VR sensor is only used as an alignment reference point for setting the correct distributor position. Figure G1 Distributor with Rotor Cap Removed Firing Order 1-3-4-2 Timing Wheel at 0 degrees TDC Figure G2 View of Distributor Rotor Cap Distributor View of Internal VR Sensor #1 Cylinder Internal VR Sensor Signal Rotor G420E/G424E Tier LP Engine Test And Adjustments 82