Idle Mixture Adjustment The method for making the idle mixture adjustment to a running engine is to use the Service Tool software by connecting a laptop computer to the SECM. If you do not have the Service Tool proceed to (step 12). A USB (Universal Serial Bus) to CAN (Controller Area Network) communication adapter by Kavaser will be required along with a Crypt Token (Figure G7). The Crypt Token acts as a security key allowing the laptop to retrieve the necessary data from the SECM. 1. Install the Crypt Token in an available USB port in the computer (Figure G8). 2.
With the ignition key in the OFF position, connect the Kavaser communication cable from a second USB port on the computer to the CAN communications cable on the engine. (*If your laptop computer does not have a second USB port an appropriate USB Hub will need to be used). 3. Connect a timing light to the engine. 4. Turn the ignition key to the ON position (Do Not Start the Engine) . 5. Launch the MotoView program on your computer and open the Service Tool display. 6. Start the engine; you should now see the idle RPM on your Service Tool display Run Screen (Figure G9).
NOTE Service Tool software (MotoTuneViewer) and the security Crypt Token is obtainable by certified technicians through authorized dealers. Figure G9 Figure G7 Crypt Token Figure G8 G420E/G424E Tier LP Engine Test And Adjustments 85