7. While on the Run Screen adjust the idle mixture screw on the mixer until a reading of 25-50% is reached for the FTV Duty Cycle (Figure G10). 8. To make this adjustment you will need to adjust the nylon screw all the way inward and then back out the screw ј turn. 9. Use the accelerator pedal to increase RPM above idle momentarily (Rev the engine) then release the pedal to return to idle RPM. The duty cycle setting should remain within the adjustment range (25-50%). 10. To obtain an accurate FTV Duty Cycle reading when the tamper proof is not installed, place your thumb over the idle screw port so that no air will leak past the screw threads. 11.
If the FTV Duty Cycle reading is above 50% back the idle adjustment screw out again and re-check your duty cycle reading. Continue to do this until the FTV Duty Cycle reading is within the proper range (25-50%) 12. Turn the ignition key to the OFF position to shut down the engine. 13. Install the tamper proof cap on the idle mixture screw adjustment port so that no further adjustments can be made (Figure G11). NOTE If the FTV Duty Cycle reading is cannot be adjusted between 25-50%, check for possible vacuum leaks, manifold leaks or a faulty mixer. Idle Mixture Screw Tamper Proof Cap Figure 10 Figure 11 G420E/G424E Tier LP Engine Test And Adjustments 86