Accessories, retrofit Before installing accessories or replacing parts, please consult BAIC Motor Dealership. It is recommended to use accessories and parts approved by GAC. It is forbidden to install other high-power electrical equipment other than those in the original configuration. The addition of high-power appliances other than the rated power will cause the wiring harness to heat up and short circuit due to excessive load, which may cause a fire. Unfitted retrofit will seriously damage the performance of the vehicle, and even cause serious accidents, such as:
Operating system and equipment When installing vehicle traveling data recorder, navigation system and DVD player, do not change the harness at will. ● Installing larger or smaller wheels will affect the normal operation of the vehicle's antilock brake system (ABS) and other systems. During installation of harness, wiring with high internal resistance will generate high heat, which may cause fire. ● Retrofit of the steering wheel and other safety facilities may cause a related system failure. ● On vehicles equipped with side curtain airbag, installing other accessories at the side rails on both sides of the roof will prevent the normal operation of the side curtain airbag.
The use of high power bulbs is prohibited If a bulb that exceeds the rated power is used in order to make the light brighter, the harness will be overloaded, which may lead to a fire. 103 Purchase channel and contact information: BAIC INTL 400-810-8100. Retrofit to the front of the vehicle may impair the pedestrian protection of the features. Diagnostic scan tool system at this stage: PAD diagnostic scan tool kit. Improper attachment or retrofit may weaken the protective effect of the airbag system and even cause fatal injury.
Installing accessories such as beverage cup holder and telephone bracket on the cover of airbag system or within the scope of airbag system will cause serious personal injury when airbag is deployed. Do not apply bottom protective layer or anticorrosive material to exhaust ducts, catalytic converter, or insulation boards, so as not to affect heat dissipation.