Starting and driving frequently, pay attention to the change of the sound and temperature of each assembly in operation. higher than normal, so the engine oil should be checked regularly. Running-in of new vehicle Precautions for running-in Only after running-in of all moving parts of the engine can the best matching state be achieved. In order to improve the service life of the vehicle, the new vehicle shall be running-in at the initial stage of use before it can be used normally. The following are the rules of the running-in period: ● Do not run the engine at a fixed speed for long time during running-in.
Engine running-in Running-in tyre and brake pad After the required running-in, the engine can not only prolong the service life, but also reduce the fuel consumption. New engines or overhauled engines must undergo running-in before normal use, and the following regulations must be observed during the running-in period: In the first 500 km, the vehicle should be driven at a moderate speed to achieve a good running-in of the new tires. Driving Guide ● The mileage in the running-in period is: 1500 km ● Choose a better road and drive with light load.
In the first 500 km, the new brake pad and the brake disc cannot reach the best friction, so it should avoid emergency braking, keep enough safety braking distance. ● The vehicle speed should not exceed 80% of the maximum vehicle speed. ● Avoid running the engine at high speed, never exceed 80% of the maximum speed. ● Do not press the accelerator pedal to the bottom for rapid acceleration driving. ● Do not tow other vehicles. ● Avoid emergency braking within the first 500 km. In 1,000-1,500 km, you can gradually increase the engine speed and vehicle speed to the highest allowable range. Strictly implement the operating procedures and maintain the normal operating temperature of the engine.
Do the daily maintenance of the vehicle carefully, check In the early stage of running-in, the internal friction resistance of the engine is much larger than that after running-in, and the oil consumption may be 104 New tires and brake pad that have not been running-in do not have the best adhesion and friction, so you must drive carefully within the first 500 km to prevent accidents. The replaced new brake pad must also be running-in according to the above requirements. Keep a proper distance from other vehicles when driving to beware of situations requiring emergency braking.
Because the tires and brake pad have not been running-in at this time, the adhesion and friction are insufficient, which may easily cause traffic accidents. If the engine machine or other transmission systems of the vehicle are replaced, the running-in precautions should also be observed.