restore its performance. Salted roads: while driving on a road with salt spray, if the brake is not used for a long time, there will be salt on the brake disc and brake pad, and the braking efficiency will be reduced. In this case, gently step on the brake pedal several times to remove the salt on the brake disc and brake pad. When using engine auxiliary braking, the lower the transmission gear, the higher the engine speed, the greater the drag, the more obvious the braking effect. Factors affecting braking effect 4.
Plateau environment Due to the thin air and low air pressure in plateau areas, the brake vacuum boost will become smaller, so it is necessary to apply greater brake pedal force when braking in plateau areas. When braking is required, do not step on the brake pedal by cadence braking but keep your foot on the brake pedal to ensure braking efficiency by controlling the force applied on the brake pedal. 1. Wear The wear of brake pads depends to a large extent on the service conditions and driving style, especially for those vehicles that are often driven in urban traffic and short distance or in sports mode.
Therefore, it is necessary to check the thickness of the brake pad within the specified interval for maintenance. 3. Mountain environment As there are high mountains and long slopes in the mountainous environment, the brakes are used frequently for a long time, and often work continuously under high-intensity braking conditions, all these factors above-mentioned will worsen the braking efficiency. Therefore, when the vehicle is going downhill, do not coast in neutral and avoid frequent braking.
Try to use a low gear to control the vehicle speed through the auxiliary braking effect of the engine, which can reduce the working intensity of the wheel brakes and reduce the temperature of the brakes. Driving Guide 2. Wet or salted road Wet roads:
during driving in ponding, heavy rain, or after car washing, where the brake discs and brake pad are wet or frozen at low temperature in winter, the braking efficiency is reduced, so please gently press the brake pedal a few times to dry the brake and 115 When the vehicle is running normally, do not habitually put your foot on the brake pedal, otherwise the brake will be overheated by accidentally stepping on the brake pedal, which will reduce the efficiency of the brake, shorten the service life of the brake pad, and increase the fuel consumption of the vehicle. Keep the brake lights on will also cause the rear driver to misjudge the road conditions ahead.
When driving, make sure to keep a sufficient distance from other vehicles to ensure sufficient reaction time and braking distance for emergency braking. When driving the vehicle, if the engine is stall, do not use multiple consecutive brakes, otherwise the vacuum degree of the vacuum booster will be reduced. At this time, it is necessary to continuously step on the brake pedal with a lot of force to slow down and stop the vehicle.