Manual initialization and self-learning of sunroof steps to initialize again. Sunroof sun visor Lamplight combination switch In some cases (such as a sudden power failure of the battery or after the vehicle has not been operated for a long time), it may be necessary to manually perform initialization and self-learning of the power sunroof. The sun visor can be opened together with the sunroof, but it needs to be manually pulled back to close. Tilting ventilation on/off Operating system and equipment The start/stop button is in "RUN" mode.
When the sunroof is in the closed state, press or touch the "TILTUP" button for a long time, and the rear of the sunroof glass will rise, tilt to the open position and stop automatically. During the tilting process, press the sunroof control button, and the sunroof glass will stop at the current position. The specific operations are as follows: ① Light control knob 1. Switch the start/stop button to "RUN" mode within 5 seconds and then switch it off and back to "RUN" mode. ② Fog lamp control lever ③ Light control lever 2.
Within 5 seconds after the first step, press and hold the sunroof "TILT UP" button, the sunroof glass will be fully cocked, after a "click" sound, the sunroof glass will be operated as follows: fully closed - fully open - fully closed. After this process is completed, the sunroof stops running, release the button, and the sunroof glass initialization process is completed. The start/stop button is in "RUN" mode. Press and hold the "SLIDE OPEN" button to close the sunroof, and the sunroof does not have anti-pinch function during this process. (If the "SLIDE OPEN" button is tapped, the sunroof glass has the anti-pinch function during closing).
If the sunroof initialization fails, you need to follow the above 68 To ensure driving safety, the driver is prohibited from operating the sunroof switch while driving the vehicle. When the sunroof is open, do not forcibly close the sunroof sun visor.