Turn on the hazard warning lamp in the following situations: Emergency braking signal When the speed exceeds 50 km/h and emergency braking occurs, the brake lights will flash; When the vehicle speed exceeds 70 km/h, emergency braking occurs and the emergency braking continues until the vehicle speed drops below 10 km/h, the brake light will flash and the hazard warning lamp will be turned on automatically; After that, if the vehicle releases the brake, accelerates to more than 20 km/h, and maintains that speed for more than 5 seconds, the hazard warning lamp will automatically turn off; The hazard warning lamp can also be turned off manually by operating the hazard warning lamp switch.
lamps are not off. Interior light Door Open Light Up function ● When the vehicle breaks down due to technical failure. Front reading lamp * ● When the vehicle is blocked by traffic and is at the end of the train. Operating system and equipment ● In case of emergency. ● When towing another vehicle or being towed. When the hazard warning lamp switch is pressed, all turn signal lamps, and the two turn signal indicator lamps in the instrument cluster will flash at the same time. Press down switch to turn on the Door Open Light Up function.
Pressing the switch , the driver's side reading lamp will be lighted up; After 10 minutes of lighting or within the time, press the switch again and the reading lamp will go out. When the start/stop button is in the "RUN" mode, open any door and front reading lamp is on. The hazard warning lamp will still operate even when the start/stop button is in the "OFF" mode. To turn off the hazard warning lamp, press the hazard warning lamp switch again. After the doors are closed, the front reading lamp will gradually go out. If any door is not closed, the front reading lamp will stay on for about 30 seconds and then go out.
Pressing the switch , the side reading lamp of the front passenger will be lighted up; After 10 minutes of lighting or within the time, press the switch again and the reading lamp will go out. Running lamp on alarm When the start/stop button is in the "OFF" mode, the light switch is in the position lamp or low beam position and the vehicle position lamp is on. At this time, if the driver's door is opened, the instrument will send an alarm that the running 73 When the engine is not started, if there is no special need, do not turn on the hazard warning lamp for a long time to avoid battery loss.