The wiper and washer only work when the start/stop button is in the "RUN" mode. If during the wiper operation, the start/stop button is not in the "RUN" mode, the wiper will stop the operation immediately. It will return to the initial position, until the next time in the "RUN" mode. Models with rain sensor* When the system senses rain, the keyless start/stop button is at "RUN" and the wiper switch is at "AUTO", the windshield wiper will be automatically turned on and the wiping speed will be changed according to the amount of rain. Operating system and equipment To select a gear, push up or down the control lever. The intermittent time adjustment lever:
toggle this lever and adjust the wiping intermittent time for the front wiper. The interval time is divided into four levels, with level 4 to move the lifting lever up to the maximum (the shortest interval time), level 1 to move the lifting lever down to the lowest (the longest interval time), and level 3 and level 2 in the middle position in turn. Adjust the automatic wiping speed to suit your own driving habits. When the wiper control lever is in "LO" (low speed wiping) or "HI" (high speed wiping) position, the front wiper will wipe at the set speed, and the automatic sensing function will not work at this time. HI: quick wiping of the front wiper ① HI: high-speed wiping LO:
slow wiping of the front wiper ② LO: low-speed wiping ③ AUTO: automatic wiping INT: The front wiper is in intermittent wiping state. ④ OFF: stop OFF: the wiper does not work. ⑤ MIST: single wiping MIST: the wiper control lever will automatically jump back to the "OFF" gear when it is turned to the "MIST" gear and released, at which time the front wiper will wipe once at low speed. When the wiper control lever is shifted to "MIST" and held, the front wiper will keep on wiping until it is released. ⑥ Automatic wiper sensitivity adjustment lever 76