BAIC U5 PLUS series — 1 (39)(1)

Rain/light sensor* The rain/light sensor is located on the front windshield near the interior rearview mirror. If the sensor is covered by mud, oil, dust, etc., the wiper "AUTO" gear, the headlamp auto-illumination function and the sunroof may not work normally. If strong light, infrared light, objects, etc. appear above the rainfall/light sensor, a wiper start may occur. Windshield washing Operating system and equipment The automatic wiping sensitivity of the system can be adjusted by rotating the automatic wiping sensitivity adjustment knob.

When the start/stop button is in the "RUN" mode, turn the wiper control lever toward the steering wheel, the washing motor starts to work, and the front windshield washer nozzle sprays water. Release the button to stop spraying water, and the front wiper automatically stops after several times of continuous wiping. The sensitivity is divided into four levels, with level 4 to move the lifting lever up to the maximum (the highest sensitivity, easy to scrape at high speed), level 1 to move the lifting lever down to the lowest (the lowest sensitivity, not easy to enter the high-speed scraping), and level 3 and level 2 in the middle position in turn.

Adjust the sensitivity of the automatic wiper to suit your own driving habits. 77 In low temperature conditions, when performing wiping operations, make sure that the wiper blades are not frozen on the windshield. In winter, the snow and ice on the wiper arm and wiper blade shall be removed in time, including the area involved when the wiper is working. Do not place the wiper control lever in the "AUTO" position when washing the car with the automatic car washer, otherwise the wiper may be damaged. The system shall be switched off when the wiper is not needed.