Periodic maintenance and adjustment 2. Loosen the fasteners, and then remove the side cover. 1. Screw 2. Cable guide 1. Fastener 2. Right side cover 3. Loosen the quick fastener screws, dis- connect the main switch coupler and aux- iliary DC jack coupler, and then remove the top cover. 1. Fastener 2. Left side cover To install a side cover 1. Place the side cover in the original posi- tion, and then tighten the fasteners. 2. Install the shroud. 1. Quick fastener screw 2. Top cover To install the top cover 1. Connect the main switch coupler and auxiliary DC jack coupler, place the top cover in the original position, and then tighten the quick fastener screws. 2.
Pass all of the cables, etc., through the cable guide, place the cable guide in the original position, and then install the screws. 3. Install the shroud. TIP Be sure to fit the projection on the rear of the side cover into the hole in the lower side cov- er. Top cover To remove the top cover 1. Remove the shroud. (See the above pro- cedure.) 2. Remove the screws, and then remove the cable guide. 42