Periodic maintenance and adjustment 6. Check for any coolant leakage. TIP If you find any leaks, consult a Yamaha deal- er. 7. Install the top cover. ESU12062 V-belt EWS00401 1. Coolant reservoir cap 2. Coolant recovery tank cap G Coming in contact with the rotating V- belt or clutch parts can cause severe in- jury or death. Never run the engine with the drive guard removed. 3. Remove the coolant recovery tank cap, add the recommended coolant until it reaches the “COLD LEVEL” mark, and then install the cap.
G Make sure that the drive guard is tight- ened securely before operating the snowmobile to protect against severe injury or death from a broken V-belt or other part should it come off the snow- mobile while it is in operation. ECS00830 NOTICE Never run the engine with the V-belt re- moved. Clutch components can be dam- aged. The V-belt should be checked before each ride. To check the V-belt 1. Remove the shroud and the left side cov- er, and then remove the drive guard. (See page 41 for removal procedures.) 2. Check the V-belt for wear and damage. Replace if necessary. Recommended antifreeze:
High-quality ethylene glycol antifreeze containing corrosion inhibitors Antifreeze and water mixing ratio: 3:2 Total amount: RX10GT 6.20 L (6.55 US qt, 5.46 Imp.qt) RX10LTGT 6.80 L (7.19 US qt, 5.98 Imp.qt) 4. Start the engine, allow it to idle for several minutes, and then turn it off. 5. Check the coolant level in the coolant reservoir. If it is not full, remove the cool- ant reservoir cap, fill the reservoir with the recommended coolant, and then install the cap. 53 WARNING