Yamaha Motor Corporation RX10GTY/RX10LTGTY — Periodic maintenance and adjustment

Periodic maintenance and adjustment 3. When installing a new V-belt, make sure that it is positioned properly. Otherwise, the V-belt clutch engagement speed will be changed and the snowmobile may move unexpectedly when the engine is started, which could cause an accident. 1. Edge of the secondary sheave assembly 2. Spacer 3. V-belt position adjusting bolt ECS00510 As the V-belt wears, adjustment may be necessary. To ensure proper clutch per- formance, the V-belt position should be adjusted by adding a spacer on each ad- justing bolt when the V-belt position reaches 1.5 mm (0.06 in) below the edge of the secondary sheave assembly. Have a Yamaha dealer make this adjust- ment.

NOTICE TIP Apply the parking brake before replacing the V-belt. 1. Remove the shroud and the left side cov- er, and then remove the drive guard. (See page 41 for removal procedures.) 54 WARNING